sub wover
In past years, square, triangular, hexagonal and pentagonal subwoofers have tried to change & excite the marketplace.
The very simple fact is that if you have any given area, a square woofer will yield the most cone area which means higher SPL.
Even so, most square woofers have been poorly designed and do not meet the expectations.
The PSQ subwoofers are engineered from the ground up, and do yield higher SPL than any of our other subwoofers!
• 28% More Cone Area Than Round Woofer
• Stamped Steel Basket w/ Rolled Edges
• Aluminum Voice Coil Former
• Direct Wire Terminal Design
• Injection Molded Polypropylene Dust Cap
• Silver Polypropylene Cone
• Multi-Roll NBR Rubber Surround
• Vented Back Plate
• Suspension Integrated Tinsel Leads
AWB-12P 1000 Watts MAX active woofer box with built in amplifier
• Black piano finish
• Bass knob remote control
• P.W.M. Mosfet power supply
• Phase switch (normal/reverse)
• Thermal/short/over load protection circuit
• Power & distress indicator
• Variable low pass (50-150Hz)
• Soft delayed remote turn-on
• 0-12dB variable bass EQ at 45Hz
• Low & high level inputs
• Auto cooling
• Two 12” woofers (one passive without magnet)
• 4 Ohm impedance
• S/N ratio: 93dB
• Dimensions: 18.5” X14.75” X9.7”
AWB-10 800 Watts MAX active woofer box with built in amplifier
• Bass knob remote control
• P.W.M. Mosfet power supply
• Phase switch (normal/reverse)
• Thermal/short/over load protection circuit
• Power & distress indicator
• Variable low pass (50-150Hz)
• Soft delayed remote turn-on
• 0-12dB variable bass EQ at 45Hz
• Low & high level inputs
• Auto cooling
• Two 10” woofers (one passive without magnet)
• 4 Ohm impedance
• S/N ratio: 91dB
• Dimensions: 16” x 12.3” x 9.5”
Subwoofers do not need to have monster magnets to work properly. These allnew drivers are great for the modest powered system and yield great sound quality and much lower bass than the previous models. Each model features a molded Polypropylene cone and Butyl Rubber surround for great performance and durability. Dual 4-ohm voice coils are wound on Kapton formers for versatility and better heat dissipation. Check out the new entry level drivers and see for yourself that lost cost subs do not have to sacrifice performance!
• Polypropylene Injection Molded Cone
• Butyl-Rubber Surround
• KSV Kapton Voice Coil
• Nickel Plated 8 ga. Compression Wire Terminal
• Poly Cotton Spider
• Texture Coat Finish on Stamped Steel Basket
• Suspension Intergrated Tinsel Leads