The Air Inlet Manifold unit is made of plastic. The flange that attached the unit to the engine body was broken. This allowed the inlet manifold unit to rotate a few degrees clockwise. This resulted in the butterfly valve axis being off so when the accelerator wire pulls and rotates the valve it was not able to go back to idle position.

it was only lubrication of the cable and the pedal that solved the problem

2

that the air filter box was loose and not properly tightened. On removing the box, the throttle body was not in its proper place.


3

There was a marked difference in acceleration after proper seating and tightening.

كمثال









:1201 05~352::120105~35 2: