المشاركة الأصلية كتبت بواسطة cars admire

كلاتش سيرفو بجوار الفتيس !!!


!solenoid!


















http://community.webshots.com/user/vw68autobug









شكر خاص لمستر هشام الجزار !!



















فيات 124 و131 كمحرك خلفى !!











124 كدفع امامى او خلفى لاكن لازم يتركب بالعرض !الفتيس يؤكد زلك !يا ترى فيات ركبته
على عربية ايه ؟؟؟؟!!




be lucky enough to find a good VW gearbox and a man to makes up the adaptors and flywheels to fit between the Fiat engine block to VW gearbox
للبيع سيات 133 2000 سى سى
Seat/ Fiat 133

Factory date: 01/2011 Price: Offer!!! Details: Just made from new parts!! fiat 2.0 TC engine with Weber carburators. Programmable ignition system, ignition timing after every 500 rpm, launch control, shift light, rev limiter. Hydraulic handbrake. New fuel and brake lines. New electric cables etc Polycarbonate windows but not windshield (it is glass). VW beetle´s fully made short ration gearbox with bog 2-gear. Don´t hesitate to ask more!! Contact Name: Ville-Pekka Vaara Contact Phone: +358 44 553 82 59

للبيع سيات 133 2000 سى سى
As mentioned elsewhere, close ratio 3rd and 4th gears are available for the standard Fiat 850 4 speed gearbox as is a small number of 9/35 ring and pinions (3.888 to 1)(without limited slip diff) for the same standard gearbox , both more suitable for the higher power motors.




Fiat 128 cardans on the outer end and made the side plates with VW type 1 gearbox joints for the inner side. Works great, but a lot of work.

So the man designed a new system. It incorporates the following items:

2 gearbox side flange kits with a bearing and seal (no rubber boots required)
2 gearbox stubaxles set up to use standard "square stones". Use yours as Fiat made two different sizes.
2 Tripode housings with tripode and rubber boot 70mm diameter. - these bolt directly to the side flange kit and are replaceable.
2 axles splined both ends
2 tripode housings with tripode and rubber boot 70mm diameter - wheel hub end - fits inside Fiat 600 trailing arms without modifications
2 stub axles
2 bearing carriers
2 wheel bearings
2 wheel hubs (you could use Fiat 128 wheel hubs if you wanted.

There you have it, a complete system with all parts individually replaceable.

this man have the prototype done and with the manufacturer at this point. he just waiting to get the first shipment in. he have not been able to set a price as this time.